On the convertible body there is a deck filler panel that fits between the trunk and the area where the convertible top is stowed. Until early this year this part was not available. I was glad to see that Dynacorn has released this part. So I ordered it right away. Once it arrived I double checked its fit before removing […]
» Read more
If you recall in the last post, I showed a picture of the lower door jamb and the rust hole. Today we fix that. The sequence of pictures below show the steps. First I cut out the rusted area, you can see that there are two panels sandwiched together, so I cut them out at different places, as shown in […]
» Read more
In the last post I set up the doors and trunk as to get a body reference lines. With all the references set up for the doors and Trunk lid, etc. I started by taking measurement of the placement of the rear quarters on the tail panel. I also check the angle of the top of the quarter panel. This […]
» Read more